|Website:||Open website in new window|
Workboat Brief Owners description)
Draft - Forward 2-3ft +/- . Aft 5 ft +/- (4ft +/- with drive leg up) ( Approx )
'She is totally flat bottom and drys out on an even keel, the engine and therefore hydraulics can be run when the she has 1ft of water around the back end for cooling.
The raised wheelhouse makes un-obscured operating and keeping eye on deck operations and surroundings very easy with plenty of room inside for breaks and shelter from the weather.
The 3t winch is situated forward on center line however the winch wire travels aft and around a turning capstan before going forward to the bow roller meaning an uninterrupted, non stop winch pull of upwards of 80ft +/- from the waterline! The crabne is situated just to the starboard side of the fore deck ensuring maximum lifting capacity at the bow.
A real selling point of the this boat is the full standing height, fully lit workshop down below, this work shop is full width and 28ft long, there is a full size work bench and 3 phase generator down there as well as ample shelving. It is ideal for crew changing and all workshop needs as well as stock storage with a removable deck 9'x5' deck section.
Lastly the engine was removed and totally rebuilt including new liners etc in 2015
|Engine model:||Ford D6 Cylinder|
|Maximum Speed:||4 Knots|
|Length over all:||15m|
Ford D6 Cylinder 120 BHP
Generator 3 phase
3 Ton deck winch
Bonfiglioli 7200 Crane
Sea windlass winch
Whilst every care has been taken in there preparation, the correctness of these particulars is not guaranteed.
The particulars are intended only as a guide and they do not constitute a term of any contract.
A perspective buyer is strongly advised to check the particulars and where appropriate to have the vessel fully surveyed and inspected, sea trialled and opened up
Note: Indicated location is approximate general area only.